Products > Resistance Barriers

VR-M3 Vertical Resistance Barrier

Visual Warning: The VR-M3 provides hard-to-miss visual impact to alert motorists to a road-blocked condition. Arm surfaces are painted gloss white and front and rear surfaces of the arm are covered with a strip of highly reflective diamond grade sheeting with alternating red and white stripes for superior visibility in all lighting conditions.

Intrusion Resistance: For sites where the intent is to stop errant vehicles while protecting occupants rather than to debilitate the vehicle, the VR-M3 offers an ideal choice. The VR-M3 incorporates a unique energy-absorption system through the use of concealed continuous straps running inside the arm tube and looping around anchored bollards at each side of the roadway. By selecting appropriate straps, the stopping capacity of the barrier can be tailored to suit individual installation requirements.

Ease of Operation: For remote or infrequently-operated sites or locations where electrical power is inconvenient or unavailable, the manual operation of the VR-M3 provides a solution. Counterweights balance the arm for smooth and easy operation requiring minimal force on the built-in handle. An automatic latch engages the gate to hold it firmly in both the lowered and raised position and is easily released to allow operation. An adjustment plate allows easy, accurate adjustment of the lowered position to accommodate sloped roadways. Padlock hasps are provided to lock the gate in either the lowered or raised positions when the gate will be left unattended.

Typical Applications:

  • Emergency Egress Route Access Control
  • Checkpoints
  • Controlled Entrance/Exit Gates

Specification

GENERAL: The barrier gate shall be Model VR-M3, manually operated, as manufactured by B&B Roadway, (888) 560-2060.

APPLICATIONS: The barrier shall be designed for use as a warning, traffic control and access control gate where manual operation is desired for closure of up to two lanes.

GATE STAND and MOUNTING PROVISIONS: Gate stand shall use heavy structural steel, welded in a rigid configuration. Entire stand shall be hot dip galvanized after fabrication. The base shall be mounted to a foundation specified by the project engineer with four 3/4" diameter by 12" long L-shaped anchor bolts or alternate anchor bolt as specified by the project engineer.

SIDE ARM CHANNELS and CROSSMEMBER: Steel, hot-dip galvanized side arm channels and cross members shall form a sturdy mounting frame to support the arm. The cross member section shall provide for mounting of the arm base.

LATCHING / LOCKING PROVISIONS: The design shall permit 90 degree vertical rotation of the arm. An adjustment plate shall allow adjustment of the raised and lowered positions to account for sloping roadways. The arm shall latch in both the open and closed positions. Provision for padlocking shall be provided in both the raised and lowered positions.

BEARINGS: Permanently lubricated, bronze spherical bearings shall be provided as standard equipment for smooth, reliable operation.

ARM: The gate arm shall be 4" square (102mm), 6005-T6 aluminum extruded tubing, fitted with an aluminum eye at each end to slip over the bollards. Standard maximum clear opening between the bollards shall be 30'. Front and rear arm surfaces shall be covered with red and white diamond grade reflective sheeting. Stripes shall be 6" (152mm) wide, and shall slope at 45 degrees down toward the arm tip. Remaining exposed arm surfaces shall be painted white.

RESISTANCE STRAPS: Inside the arm tube shall run a continuous loop or loops of nylon strapping, of a size and quantity to suit the capacity requirements of the project. Resistance straps shall be guided through the eyes at each end of the arm such that the loop will engage the bollards in the arm-lowered position. Arm design shall fully enclose the straps to protect them from exposure to sun and weather so far as possible.

BOLLARDS: A pair of heavy steel bollard posts shall be mounted on either side of the roadway. The bollards shall be designed as the load carrying structure in the event of a vehicle collision and shall have a lip to assist in retaining the resistance straps.

WARRANTY: A 1 year warranty shall cover the gate and related equipment against defective material and components.